TonCut is intended for cutting optimization of flat (2D) and long (1D) materials, such as: glass, wood, stone, metal, aluminum, plexiglass, cardboard, tubes, bars, etc.
Program can't find any proper result! What should I do?
Check that the materials are big enough to contain the smallest pieces.
If using a structure, make sure that the pieces match the material in this regard. If the material does not have any structure and the pieces need it, the program will not find any result.
Remember that the kerf also takes some space on the material. If your pieces have dimensions close to the size of the material, enable the Allow cuts on edges option.
If your pieces have dimensions close to the size of the material, remember that the minimum cut width is set. This means that the material must have at least the same size as the piece plus the kerf, plus the minimum cut width.
If Cut depth limit is enabled, make sure that it is possible to arrange the pieces to fit the material. Take piece structures and sizes and direction of the first cut into account.
If materials have formatting set, it requires to take cut depth limit into account in the configuration. If so, consider the need for additional margin cuts. In practical terms this means the depth limit must be set to 3 or 4 cuts and not 2, if you want to cut in strips. The exact value depends on the number of cuts and the cutting method.
If Cut length limit is set. Make sure that the pieces can be arranged so that the cuts do not exceed the set limit.